I have noticed when copying and pasting a part of the map that the height field changes in the opposite direction or just gets really messed up. Happens on every install of AC I have.
|
Copy Paste - Map Editing
|
13 Jan 12, 10:24PM
Ya there are. I tried copying and pasting to save time and it just didnt work.
14 Jan 12, 12:49AM
I think you misunderstood. For example I raise a 3x3 square ofcubes by 4 blocks
. Then I give it a left tilt. If I copy and paste it comes out with a right tilt. 
14 Jan 12, 12:56AM
Where are you copy and pasting to?
You may not be copy and pasting all of the right cubes, and pasting too close together. Try expanding your C+P by one cube on each side (so if you had a 3x3 selection, make it a 5x5) 
14 Jan 12, 01:01AM
It's because heightfield "nodes" are at each intersection, rather than the cubes themselves -- meaning you will have to copy an area containing each of the nodes.
14 Jan 12, 11:44PM
Select the area, copy, paste and type this command:
[SELECT ALL] Code: /selectionrotate 90
14 Jan 12, 11:46PM
I don't think he means on the SVN (though yeah the SVN needs refreshing after every paste I do o_O)
14 Jan 12, 11:51PM
15 Jan 12, 01:30AM
(This post was last modified: 15 Jan 12, 01:31AM by Felix-The-Ghost.)
I thought you were referring to the glitch that screws up copying/pasting in SVN (at least on my computer) where the destination is rendered like a flashing mirror or whatever.
 (14 Jan 12, 01:01AM)Felix-The-Ghost Wrote: It's because heightfield "nodes" are at each intersection, rather than the cubes themselves -- meaning you will have to copy an area containing each of the nodes. Exactly, so take a 4x4 surface where the little red dot is in. :) (take the same surface than if you would edit all the heightfields you want to copy/paste) Then rotate etc...do what you want with it and paste it. :p |
|
« Next Oldest | Next Newest »
|
