Modeling question

[Cjankowski]

Hi all. I was mapping a n urban type map and see on some other maps people are able to round off a section of cubes like for side walks and huge cylinder type pillars. I've learned how to arch doorways and such as well as slope but cannot figure this one out. I played with arch sideways and still nothing. What am I doing wrong?  Any help would be appreciated and thanks in advance.

[Mr.Floppy]

Not sure if I understand correctly, but I guess you want to make corners, which is done by selecting one cube and hitting 'k'. For instance, make a pillar of 3x3 cubes. Now select one of the outer cubes and hit 'k'. Hit 'k' again to un-corner it.

[Robtics]

assuming you mean highfielding, you can select cubes and press "h" (floor) and "i" (ceiling) .. then press "8" to raise them or "9" to lower them

[Cjankowski]

Thanks the K key works! Cornering the edges is exactly what I was looking to do.