07 Feb 13, 10:00AM
HI guys....my port i just fowarded was deleted by my dad..so, i want to port foward again but i forgot the instruction i just have....can anyone help me?
|
How to port foward in mikrotik again?
|
TCP packets:
[SELECT ALL] Code: /ip firewall nat add action=dst-nat chain=dstnat dst-port=<Port to portforward from> in-interface=<WAN interface> protocol=tcp to-addresses=<IP address to portforward to> to-ports=<Port to portforward to> [SELECT ALL] Code: /ip firewall nat add action=dst-nat chain=dstnat dst-port=<Port to portforward from> in-interface=<WAN interface> protocol=udp to-addresses=<IP address to portforward to> to-ports=<Port to portforward to>Last parameter may be omitted, if you don't need it 
so...i should put tcp too?
or only UDP?
It didn't work....i remember the last instruction put a masquarade after dst actions....
But I forgot the first instruction... 
08 Feb 13, 01:10PM
08 Feb 13, 01:56PM
(08 Feb 13, 01:10PM)OpenSource Wrote: http://wiki.mikrotik.com/wiki/Manual:Ini...forwarding it didn't work at all...
10 Feb 13, 03:31AM
10 Feb 13, 04:35AM
Hmm you're right.
What went wrong when you followed the instructions on the wiki links OpenSource posted?
Well i tried it and it didn't work at all...
I open the all links and follow instruction and then didn't worked at all...
11 Feb 13, 09:16PM
Ok. You haven't given us much, if any, information to work with there.
Have you tried a factory reset then try the instructions on the wiki again? |
|
« Next Oldest | Next Newest »
|
