28 Apr 11, 03:28AM
Well i setted up my static ip on my IPv4 address like this:
Use the folowing IP Address:
IP Address: 192.168.2.2
Subnet Mask: 255.255.0
Default Gateway: 192.168.2.1
Use the following DNS server addresses:
Preferred DNS Server: 192.168.2.1
Alternate DNS Server: 192.168.2.2
Thats how i have my static IP set up on my IPv4 address. I went to that by going to:
Control Panel --> Right Clicked Local Area Connection--> Than Properties--> Than chose IPv4 address--> Clicked Properties and thats where i set up my static ip.
But There is one thing that i am probably messing up on forwading my router.My router is a Embarq Zyxel 660 Router. But my Zyxel router doesnt have a option that says Portforwarding or an option for games it does not have that. What i porforwaded on was NAT because that was the only option that i could find so i portfoprwarded on my router like this:
Start Port No: 28763
End Port No: 28764
IP Address: 192.168.2.2
192.168.2.2 is IPv4 Addresss. Thats the address i put for my Server.
Than i went to firewall and chose a rule. I named it ac server and this is what i put:
Service name: ac server
Service type: UDP
Port Range from: 28763 to 28764
I applied it and added it to my selected services. Also i have it on LAN-Wan.
Well this is what i did but i dont know if that'll work cause it hasnt been working for me i think.
Use the folowing IP Address:
IP Address: 192.168.2.2
Subnet Mask: 255.255.0
Default Gateway: 192.168.2.1
Use the following DNS server addresses:
Preferred DNS Server: 192.168.2.1
Alternate DNS Server: 192.168.2.2
Thats how i have my static IP set up on my IPv4 address. I went to that by going to:
Control Panel --> Right Clicked Local Area Connection--> Than Properties--> Than chose IPv4 address--> Clicked Properties and thats where i set up my static ip.
But There is one thing that i am probably messing up on forwading my router.My router is a Embarq Zyxel 660 Router. But my Zyxel router doesnt have a option that says Portforwarding or an option for games it does not have that. What i porforwaded on was NAT because that was the only option that i could find so i portfoprwarded on my router like this:
Start Port No: 28763
End Port No: 28764
IP Address: 192.168.2.2
192.168.2.2 is IPv4 Addresss. Thats the address i put for my Server.
Than i went to firewall and chose a rule. I named it ac server and this is what i put:
Service name: ac server
Service type: UDP
Port Range from: 28763 to 28764
I applied it and added it to my selected services. Also i have it on LAN-Wan.
Well this is what i did but i dont know if that'll work cause it hasnt been working for me i think.