could not connect to server error
#16
Are you sure you've set up your router to always assign you the same IP?
I know you said "I've done static IP", which I guess means you did - but check on the host.
You can do this via >> Start / Run / "cmd" << then enter "ipconfig" into the new window and check for the IPv4 address assigned (not the gateway, that'd be 10.0.0.138).
Thanks given by:


Messages In This Thread
could not connect to server error - by Alen - 11 Jul 10, 07:15PM
RE: could not connect to server error - by flowtron - 13 Jul 10, 09:19AM